I had a tough time fitting the rear panel. It took some time and patience.

I had to fiddle a bit with the side scoops. Not bad though.

Had to sqeeze the body over the engine.

I used Keith Marks decals, as the kit decals are pretty poor.

N/A

-Interior kinda bland
-tight fit
-wheels are pretty crappy

Overall a nice build. This was the first model ive built and ive done it about 5 times since. Makes a very nice model when finished

Body was slightly misshapen, like it had been "squished" width-wise. This made fitting the interior tub, windshield, and front and rear pans a real hassle. Rear pan has glaring gap as a result that would require much filling.

Hood sits loose when closed, and will not stay up when opened, may be due to the slight distortion of the body

Grille area is recessed and takes great effort to paint correctly

Flaws aside, finished model looks very good, will look as good as the effort put into it.

-my chassis was seemingly warped, as if it was molded crooked, which makes my car not set on all 4 wheels
-interior needs attention

I painted mine gloss yellow with the black stripes, and to help with the interior, I painted the floorboard and hatch carpet black and the seats and dash white and used some tan and brown for a leather look. It's decent.

Not too many complaints with this kit. The interior tub is well molded; however, the interior doors could be cut out for easier detailing. The decals are only fair and the stripe decals do not look accurate as they are a bit short. The biggest problem is in the fit of the rear panel. You will have to fill unsightly gaps. The location of the side scoops is not well defined so be careful here.

For the most part, I throughly enjoyed building this kit even though it seemed to take forever. If you are into Mustang or Shelby kits, this is a must for your collection.

There was very little detail to the interior that could be due to tooling at manufacturing. There were two areas of fit issues, one being the panel under the rear bumper and the second being a hood closure issue when the air cleaner is in place. Another disapointment would be the two piece custom chrome wheels, the back piece was fully closed and needed to be modified to give an accurate look.

Fun kit with adequate exterior and engine compartment detail. With the exception of the lower rear panel and hood fit the kit can be enjoyed by builders of any age.

Decals for custom options are thick and of poor quality. Tubbed interior with shallow detailing of the door panels. I had two kits and one of them the plating was of poor quality as it fades in a lot of parts.

The best part of this kit is the undercarriage whilst the worst part are the front valence and rear bazel. The latter leaves a noticeable gap. The kit can turn out nicely but I would not recommend it to a novice modeler.